- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
TCP/IP MIB-II
2-27
snmpInTotalSetVars {snmp 14}
Counter Read-Only
The total number of MIB objects which have been successfully
altered by the ELS10-26 as a result of SNMP SetRequest PDUs.
snmpInGetRequests {snmp 15}
Counter Read-Only
The total number of SNMP GetRequest PDUs received by the
ELS10-26, which have been processed with no errors.
snmpInGetNexts {snmp 16}
Counter Read-Only
The total number of SNMP GetNext PDUs received by the
ELS10-26, which have been processed with no errors.
snmpInSetRequests {snmp 17}
Counter Read-Only
The total number of SNMP SetRequest PDUs received by the
ELS10-26, which have been processed with no errors.
snmpInGetResponses {snmp 18}
Counter Read-Only
Always zero, since the ELS10-26 ignores all SNMP response PDUs.
snmpInTraps {snmp 19}
Counter Read-Only
Always zero, since the ELS10-26 ignores all SNMP Trap PDUs.
snmpOutTooBigs {snmp 20}
Counter Read-Only
The total number of SNMP PDUs created by the ELS10-26, with a
value of “tooBig” in the PDU’s “ErrorStatus”.