- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
2-22
TCP/IP MIB-II
icmpOutEchoReps {icmp 22}
Counter Read-Only
The number of ICMP “Echo Reply” messages sent.
icmpOutTimestamps {icmp 23}
Counter Read-Only
The number of ICMP “Timestamp (request)” messages sent.
icmpOutTimestampReps {icmp 24}
Counter Read-Only
The number of ICMP “Timestamp Reply” messages sent.
icmpOutAddrMasks {icmp 25}
Counter Read-Only
The number of ICMP “Address Mask Request” messages sent.
icmpOutAddrMaskReps {icmp 26}
Counter Read-Only
The number of ICMP “Address Mask Reply” messages sent.
2.6 TCP GROUP
tcp {mib-2 6}
The TCP Group is not supported since the ELS10-26 does not
support TCP.
2.7 UDP GROUP
udp {mib-2 7}
The TCP/IP UDP Group parameters are described below.