- Cabletron IP Router Reference Guide

TCP/IP MIB-II
2-5
ifPhysAddress {ifEntry 6}
Physical Address Read-Write
1
The MAC address of the port. For the UART port, this field should
be an octet string of zero length.
ifAdminStatus {ifEntry 7}
Integer Read-Write
The desired state of the port, i.e., one of the following:
• up (1) - setting the port’s state to up causes the port’s statistics to
be reset
• down (2) - the port is not to be used
• testing (3) - the port is to be put into local loopback (this value is
not saved if the unit reboots)
ifOperStatus {ifEntry 8}
Integer Read-Only
The current status of the port, i.e., one of the following:
• up (1) - the port can send/receive NMS packets; however,
whether or not the port has its bridging functions enabled is
unknown.
• down (2) - the port is broken, or is intentionally physically
disabled.
• testing (3) - the port is in local loopback.
ifLastChange {ifEntry 9}
TimeTicks Read-Only
The time, in centiseconds relative to sysUpTime, since the port
entered its last state (as defined by ifOperStatus).
1.
The standard MIB definition is Read-Only.