- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
7-2
Traps
authenticationFailure (4) - This trap is generated whenever the
community name in a PDU does not match the corresponding
password. All SetRequest PDUs must match the configAnyPass
(refer to the of lxadminGetPass for SetRequest exceptions),
GetRequest PDUs must match either the lxadminGetPass or the
configAnyPass. The GetRequest exception is for one of the
debugging attributes; those PDUs must always provide the
lxadminAnyPass.
egpNeighborLoss (5) - Not used by the ELS10-26.
7.2 ENTERPRISE SPECIFIC TRAPS FOR THE ELS10-26
This section lists the enterprise-specific traps that can be generated
by the ELS10-26. ELS10-26 traps contain enterprise-specific
variables that are defined in the system group of the Cabletron
MIB in Chapter 6 of this manual.
lxWriteStatusTrap (2) - Sent when a bank of Flash EPROM has been
erased. If lxswdisWriteStatus indicates success, then the unit is
ready to be downloaded with the new software.
Cabletron MIB variables include:
• lxTrapSeverity
• lxswdisWriteStatus
• lxwdisDesc
lxPortFunctionsTrap (3) - Sent whenever the current functional
state (active protocols) of the port has changed.
Cabletron MIB variables include:
• lxTrapSeverity
• lxifFunction