- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
ELS10-26 MIB
6-45
STATUS mandatory
DESCRIPTION The number of probes which are
sent for each hop. This variable
cannot be set while lxtraceOpera-
tion is on.
::= {lxtraceEntry 5}
lxtraceWait OBJECT-TYPE
SYNTAX TimeTicks
ACCESS read-write
STATUS mandatory
DESCRIPTION The time to wait in response to a
probe. This variable cannot be set
while lxOperation is on.
::= {lxtraceEntry 6}
lxtraceOperation OBJECT-TYPE
SYNTAX INTEGER {on (1), off (2) }
ACCESS read-write
STATUS mandatory
DESCRIPTION Setting lxtraceOperation to on
will begin the traceroute request.
Setting lxtraceOperation to off
will terminate the traceroute
request.
::= {lxtraceEntry 7}
lxtraceHop OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only