- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

ELS10-26 MIB
6-31
6.1.12 Cabletron Trap Management Group
This group presents the Cabletron MIB variables that are included
as varbinds with the traps generated by the ELS10-26. Chapter 7 of
this manual describes the traps generated by the ELS10-26.
lxtrapControlTable {lxtrapMgt 1}
Not Accessible
This table contains information about the severity of each trap and
whether the trap is currently enabled.
lxtrapControlEntry {lxtrapControlTable 1}
Not Accessible
The sequence of elements in the lxtrapControlTable are shown
below:
• lxtrapIndex Integer Read-Only
• lxtrapEnabled Integer Read-Write
• lxtrapSeverity Integer Read-Write
• lxtrapTex Display String Read-Only
lxtrapIndex {lxtrapControl 1}
Integer Read-Only
Identifies the specific trap number.
lxtrapEnabled {lxtrapControl 2}
Read-Write
Allows you to enable or disable the generation of this trap.
lxtrapSeverity {lxtrapControl 3}
Integer Read-Write
A user-definable severity indicating the importance of the trap.
The severity levels are defined as follows:










