- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
ELS10-26 MIB
6-23
• duplex-half (2)
• duplex-full (3)
6.1.8 Cabletron UART Interface Group
lxuartTable {lxuart 1}
Not Accessible
A list of interface entries; one per UART port.
lxuartEntry {lxuartTable 1}
Not Accessible
A set of objects for an interface entry. The individual components
are described below.
lxuartIndex {lxuartEntry 1}
Integer Read-Only
The ELS10-26’s port number of the port. This is always 25.
lxuartBaud {suartEntry 2}
Integer Read-Write
This is the desired baud rate. Only 1200 baud through 19,200 baud
are supported by the ELS10-26, but the complete set of possibilities
is:
• external-clock (1)
• 1200-baud (2)
• 2400-baud (3)
• 4800-baud (4)
• 9600-baud (5)
• 19200-baud (6)