- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
6-22
ELS10-26 MIB
lxdot3TxBabbles {lxdot3Entry 8}
Counter Read-Only
4
Counter indicating the number of packets transmitted with babble
errors.
lxdot3TxCollisions {lxdot3Entry 9}
Counter Read-Only
Counter indicating the total number of transmit collisions.
lxdot3SpeedSelection {lxdot3Entry 13}
Integer Read-Write
Speed may only be selected for the Fast Ethernet Ports. In addition,
the speed -10 mbit option (2) may only be selected for Fast
Ethernet copper ports.
The returned value reflects what has been selected, not the actual
speed value; e.g. the port may actually be 10 or 100 Mbps, but
speed-auto will be the value returned if it was previously selected.
• speed - 10mbit (1)
• speed - 100mbit (2)
• speed - auto (3)
lxdot3DuplexSelection {lxdot3Entry 14}
Integer Read-Write
All duplex options are valid for all 10 and 100 Mbps ports. The
returned value reflects what has been selected, not the actual
duplex value; e.g. the port may actually be in half-duplex or full
duplex mode, but duplex-auto will be the value returned if it was
previously selected.
• duplex-auto (1)
4.
These statistics are only updated if the ELS10-26 has been configured to gather
extended statistics (lxadminStatsExtended).