- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
ELS10-26 MIB
6-19
lxifRxQueues {lxifEntry 19}
Counter Read-Only
Number of received packets lost because of insufficient receive
buffers.
lxifStatisticsTime {lxifEntry 27}
Time Ticks Read-Only
Length of time during which statistics were collected. In particular,
the following statistics may be examined to determine the exact
utilization rate of a port:
• ifInOctets
• ifInUcastPkts
• ifInNUcastPkts
• ifOutOctets
• ifOutUcastPkts
• ifOutNUcastPkts
• lxifForwardedChars
• lxifFilteredChars
lxifIpAddr {lxifEntry 28}
IP Address Read-Write
The IP address assigned to the port. If this is zero, then the port
must learn its IP address via Reverse ARP or PPP’s IPCP.
lxifIpGroupAddr {lxifEntry 29}
IP Address Read-Write
Zero, or an IP group address assigned to the port.