- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
6-10
ELS10-26 MIB
lxadminDisableButton {lxadmin 21}
Integer Read-Write
An integer that can be set to prevent the push button on the front
of the ELS10-26 from controlling the LED display. Values include:
• true (1)
• false (2)
lxadminButtonSelection {lxadmin 22}
Integer Read-Write
An integer that indicates which statistic has been selected. Values
include:
• led-any activity (1)
• led-rx-activity (2)
• led-tx-activity (3)
• led-any-collision (4)
• led-programmed (5)
• led-duplex (6)
When illuminated indicates Full Duplex, when dark indicates Half
Duplex.
• led-speed (7)
When illuminated indicates 100MB speed when dark indicates 10
MB speed.
• led-mirror (8)
Used to indicate which port is being mirrored by the Mirror port.
Both the MON port and the port being monitored are illuminated.