- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
6-4
ELS10-26 MIB
• true (1)
• false (2)
lxhwUpLinkManufData {lxhw 6}
Octet String Read-Only
A 32-byte array that contains the part number, serial number, and
hardware revision level of the Up-Link I/O module. The array is
valid only when the lxhwUpLink value is true. If lxhwUplink is
false, it returns an error.
6.1.2 LXSW Configuration Group
lxswNumber {lxsw 1}
Integer Read-Only
The number of file sets. This number is fixed as 2.
lxswFilesetTable {lxsw 2}
Not Accessible
lxswFileset {lxswFilesetTable 1}
Not Accessible
A set of objects for each file set. The individual components are
described below.
lxswIndex {lxswFilesetEntry 1}
Integer Read-Only
The file set number, beginning with 1 for the first file set. This
number always matches the instance of the lxswFiles. For example,
{lxswIndex 2} contains the value “2”.
lxswDesc {lxswFilesetEntry 2}
Octet String Read-Only
The description (1-255 bytes) of the software file set.