- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

ELS10-26 MIB
6-3
lxhwPortType {lxhwPortEntry 2}
Integer Read-Only
A value indicating the type of port. The values are defined as:
• csma (1) - Ethernet or 802.3 port
• uart (6) - UART port
lxhwPortSubType {lxhwPortEntry 3}
Integer Read-Only
An integer representing port type. The following values have been
defined:
• csmacd-tpx (13) – 10BASE-T with crossover
• uart-female-9pin (80)
• csmacd-100-tfx (17) – 100BASE-F
• csmacd-100-tpx (16) – 100BASE-T with crossover
lxhwPortDiagPassed {lxhwPortEntry 4}
Integer Read-Only
An integer representing the status of the port. The following values
have been defined:
• diag-passed (1)
• diag-failed (2)
lxhwAddr {lxhwPortEntry 5}
Octet String Read-Only
The unique hard-wired 48 bit MAC address for the port.
lxhwUpLink {lxhw 5}
Integer Read-Only
An integer that specifies if the Fast Ethernet (FE) Up-Link module
is installed. The following values have been defined:










