- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps
6-2
ELS10-26 MIB
sysTrapPort {sys 6}
Integer Read-Write
zero, or the UDP port number to which a second copy of SNMP
traps should be sent. Valid values are 0 through 65535.
6.1.1 Hardware Configuration Group
lxhwDiagCode {lxhw 1}
Octet String Read-Only
This variable is for Cabletron internal use only.
lxhwManufData {lxhw 2}
DisplayString Read-Only
This is a 64-byte array which contains the part number, serial
number, and hardware revision level of this unit.
lxhwPortCount {lxhw 3}
Integer Read-Only
The number of ports, including the out-of-band management port.
lxhwPortTable {lxhw 4}
Not Accessible
A table that includes information for each port.
lxhwPortEntry {lxhwPortTable 1}
Not Accessible
An entry for an individual port, keyed by lxhwPortIndex.
lxhwPortIndex {lxhwPortEntry 1}
Integer Read-Only
The port number. The value is from 1 to 25.