- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

PPP MIB
5-5
entity. The value of this object is meaningful only when the link
has reached the open state (ifOperStatus is up).
• enabled (1) - supports ACC map compression.
• disabled (2) - no support for ACC map compression.
pppLinkStatusTransmitFcsSize {pppLinkStatusEntry 14}
Integer Read-only
The size of the Frame Check Sequence (FCS) in bits that the local
node will generate when sending packets to the remote node. The
value of this object is meaningful only when the link has reached
the open state (ifOperStatus is up). 16 bit FCS is the only FCS
supported.
pppLinkStatusReceiveFcsSize {pppLinkStatusEntry 15}
Integer Read-only
The size of the Frame Check Sequence (FCS) in bits that the remote
node will generate when sending packets to the local node. The
value of this object is meaningful only when the link has reached
the open state (ifOperStatus is up).
pppLinkConfigTable {pppLink 2}
Not-Accessible
A table containing the LCP configuration parameters for this PPP
Link. These variables represent the initial configuration of the PPP
Link. The actual values of the parameters may be changed when
the Link is brought up via the LCP options negotiation
mechanism.
pppLinkConfigEntry {pppLinkConfigTable 1}
Not-Accessible
Configuration information about a particular PPP Link.










