- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

5-4
PPP MIB
• enabled (1) - supports protocol compression.
• disabled (2) - no support for protocol compression.
pppLinkStatusRemoteToLocalProtocolCompression
{pppLinkStatusEntry 11}
Integer Read-only
Indicates whether the remote PPP entity will use Protocol
Compression when transmitting packets to the local PPP entity.
The value of this object is meaningful only when the link has
reached the open state (ifOperStatus is up).
• enabled (1) - supports protocol compression.
• disabled (2) - no support for protocol compression.
pppLinkStatusLocalToRemoteACCompression
{pppLinkStatusEntry 12}
Integer Read-only
Indicates whether the local PPP entity will use Address and
Control Compression when transmitting packets to the remote
PPP entity. The value of this object is meaningful only when the
link has reached the open state (ifOperStatus is up).
• enabled (1) - supports ACC map compression.
• disabled (2) - no support for ACC map compression.
pppLinkStatusRemoteToLocalACCompression
{pppLinkStatusEntry 13}
Integer Read-only
Indicates whether the remote PPP entity will use address and
control compression when transmitting packets to the local PPP










