User guide

DPT PM2011, PM2021, PM2041W,

PM3021 HBAs

Solaris Device Driver:

dpt

Device Type:

SCSI

Adapters:

DPT PM2011, PM2021, PM2041W, PM3021

Bus Type:

ISA

Preconﬁguration Information

The EPROM should not be earlier than version 5E, and the SmartROM should not

be earlier than version 2.C.

Only two DPT adapters can be used per system.

If two adapters are installed, do not install an IDE controller.

If an IDE controller is installed, only one DPT adapter will be supported.

Supported Settings

You must use the settings in this typeface for the DPT adapter if an IDE controller is

installed:

• I/O Address: 0x1F0, 0x230

• IRQ Level:

12, 14, 15

• DMA Channel: 5, 6

• Emulation:

Disabled

Follow the instructions in “DPT PM2022, PM2042W, PM2122, PM2142W SCSI and

PM3222, PM3222UW, PM3332UW SCSI RAID HBAs” on page 55 to disable

WD1003 emulation using the DPT SCSI Storage Manager Utility diskette.

Emulation mode for drives 0 and 1 should be set to 0 indicating “no drives

present,” or there will be missing drives when the system boots.

Device Reference Pages 43