User guide

Defaults are shown in this typeface.
• IRQ Level: 2, 5,7,10
• I/O Address:
0x220, 0x240, 0x260, 0x280
• 8-bit DMA Channel: 0, 1,3
• 16-bit DMA Channel:
5,6,7
Known Problems and Limitations
The Sound Blaster card cannot share IRQ settings with any other card installed in
your system. The most common conflicts occur with the LPT1 parallel port or a
network card.
If your device is not a Plug and Play device and a hardware-jumpered IRQ setting
conflicts with another device, change the IRQ jumper setting on the Sound Blaster
card to one listed under “Supported Settings.”
Non-Plug and Play Sound Blaster 16, Sound Blaster Vibra 16, and Sound Blaster
AWE32 cards are all recognized as Sound Blaster 16 cards.
The ISA version IBM Token Ring and compatible adapters will not work in a
system that contains a Sound Blaster card that is configured at the default I/O
port address (0x220). If possible, move the Sound Blaster card to port address
0x240; otherwise, remove the Sound Blaster device from the system.
Device Reference Pages 101