User`s guide

Chapter 4: Examples
4-2 DIGITAL MultiSwitch 700 Port Based VLAN User’s Guide
4.1.1 Solving the Problem
To set up this switch, users will be assigned to two new VLANs, red
stations to the Red VLAN, and blue stations to the Blue VLAN. The
information below describes how the switch is configured to create these
two VLANs and how users are assigned to them.
1. First, the switch is set for 802.1Q operation and the operational mode
is set. Since traffic isolation is to be based on VLAN membership
alone, the switch is set to SECURE mode from the VLAN
Configuration screen.
2. The Administrator uses the Device/VLAN Configuration screen to
define the two VLANs for this switch; the Red VLAN, with a VLAN
ID of 002, and the Blue VLAN, with a VLAN ID of 003.
3. The Administrator brings up the Port Administration screen and
assigns the interfaces to the VLANs.
• Interfaces 1, 2, and 3: VLAN ID 002 (Red VLAN)
• Interfaces 4, 5, and 6: VLAN ID 003 (Blue VLAN)