User`s guide

Chapter 3: VLAN Configuration
3-12 DIGITAL MultiSwitch 700 Port Based VLAN User’s Guide
3. When the desired operational mode for the port is displayed, use the
arrow keys to highlight the SAVE command at the bottom of the
screen.
4. Press ENTER. The message “SAVED OK” displays.
3.4.2 Assigning a VLAN ID
The Port Assignment screen also enables the user to set each port’s
VLAN ID (PVID) by stepping through a list of all configured VLANs. To
assign a VLAN ID to a port in this manner, perform the following steps:
1. Use the arrow keys to highlight the MODULE field number at the
bottom of the screen. Use the SPACE bar or BACKSPACE key to step
sequentially through the available module numbers.
2. When the desired module is selected, press ENTER.
3. Use the arrow keys to highlight the VLAN ID field for the module and
port combination you wish to change.
4. Use the SPACE bar or BACKSPACE key to step sequentially through
the previously configured VLAN ID numbers. Only existing VLAN
IDs will be displayed.
5. When the desired VLAN ID is displayed, use the arrow keys to
highlight the SAVE command at the bottom of the screen.
6. Press ENTER. The message “SAVED OK” displays.
It may be necessary to use the NEXT and PREVIOUS
commands to page through the available ports on the selected
module. For instructions, refer to Section 3.4.3, Paging
Through the Port List.
New VLAN IDs must be created with the functions available on
the Device/VLAN Configuration screen, discussed in
Section 3.3.