User`s guide

Device/VLAN Configuration Screen
DIGITAL MultiSwitch 700 Port Based VLAN User’s Guide 3-9
3.3.7 Changing the Forwarding Mode
To change the forwarding mode of the switch, proceed as follows:
1. Use the arrow keys to highlight the Forward Default VLAN Out All
Ports field.
2. Press the SPACE bar or BACKSPACE to toggle between YES and
NO. The YES selection places the default VLAN (VLAN ID=1) in the
Egress Lists of all ports on the switch. The NO selection removes the
default VLAN from the Egress Lists of all ports, unless those ports
have a PVID of 1 (those belonging to only the Default VLAN).
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays.
3.3.8 Paging Through the VLAN List
To display additional VLANs that do not display in the current VLANs
List as shown on the screen, use the NEXT or PREVIOUS commands
located at the bottom of the screen, as follows:
1. To display the next screen, use the arrow keys to highlight NEXT.
Press ENTER to view the entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight
PREVIOUS. Press ENTER to view the entries on the previous screen.
The NEXT and PREVIOUS fields will only display if there are
further VLAN List entries to page through.