Specifications

6-9
Initializing the Access Server
Booting Using Console Commands
Introduction
Console functions require access server ROM Version 4.0 or greater.
If you program Flash RAM with a nonstandard boot image name and a load host
is not available, pressing the reset-to-factory button may leave the access server
unbootable.
Procedure
To allow booting of a nonstandard boot image name, perform the following steps:
Step Action
1 During the boot sequence of the access server initialization process, press
Ctrl/B two times consecutively on the port defined as the console port.
The boot process stops and the access server returns the following console
prompt:
>>>
2 At the >>> prompt, you can enter H to invoke help.
Entering H provides help text to describe the interactive boot mode
commands available. The Boot Command Options section in this chapter
lists the boot mode commands and summarizes the help text that appears
when you invoke H.
3 Choose one of the boot command options listed in the Boot Command
Options section in this chapter.