Specifications

Managing Directed TFTP

5-4

To permanently disable Directed TFTP from the DNAS command line prompt,

DEFINE the TFTP HOST to NONE. For example:

Local> DEFINE SERVER TFTP HOST NONE

To temporarily disable Directed TFTP from the ROM ﬁrmware Mini-Monitor

command line prompt, set the TFTP server IP address to zero. For example:

>>> s tftp=0

5 Initiate a boot from using the Access Server’s Ethernet interface, by entering

the "B" command at the prompt. For example:

>>> b eth:mneng2 (for DECserver 90M)

>>> b eth:wweng2 (for DECserver 700 or 900 or Access

Server 316)

6 Once the software load is complete, follow the steps listed in the previous

table to make the conﬁguration of the DTFTP information permanent.

Step Action

When DTFTP is conﬁgured on an access server and a network load is speciﬁed

(excluding a FLASH RAM load), the Access Server ROM ﬁrmware will revert to

loading from FLASH RAM after several unsuccessful retries of DTFTP loading.

NOTE