Specifications

4-7
Managing Load Hosts
DSV> USE DGD700
%CCR-I-CONNEST, connection established to remote system 08-00-2B-26-AE-32
Press CTRL/ \ to disconnect, CTRL/] to send break
# ACCESS (not echoed)
Network Access SW Vx.x for DSxxx-xx BLxx-xx ROM Vx.x-x Uptime: 0
00:16:47
(c) Copyright 1999, Cabletron Systems, Inc. - All Rights Reserved
Please type HELP if you need assistance
Enter username> Dave
Local> SHOW USER
Port Username Status Service
3 Connected
10 User 10 Connected
11 TELNET Local Mode
Local> <Ctrl/\>
Example: CONNECT Command for DSV$CONFIGURE on a DECnet Phase IV
System
The following example shows how to use CCR and DSV$CONFIGURE to connect
to a remote console port from a DECnet Phase IV system. From a user’s
perspective, the only difference between DECnet/OSI and DECnet Phase IV is the
disconnect character:
• DECnet/OSI Phase V uses Ctrl/ \ (backslash).
• DECnet Phase IV uses Ctrl/D.
DSV> USE DGD700
Console connected (press CTRL/D when finished) - ACCESS Network
Access SW Vx.x for DSxxx-xx BLxx-xx ROM Vx.x-x
Uptime: 0 00:16:52
(c) Copyright 1999, Cabletron Systems, Inc. - All Rights Reserved
Please type HELP if you need assistance
Enter username> Dave
Local> <CTRL/D>
Context-Sensitive Help for DSV$CONFIGURE
DSV$CONFIGURE provides context-sensitive help. At any prompt other than the
Local> prompt after a CONNECT/USE command, type a question mark (?) for an
explanation.