Specifications

Managing Load Hosts
4-4
$ DSV
%DSV-I-IDENT, executing DSV$CONFIGURE version x.x.x-nnn -
DSV-I-HELP, type ? any time for help
DSV> HELP
ADD - Add a server to the system
MODIFY - Modify an existing server's information
SET - Synonym for MODIFY
DELETE - Remove a comm. server from the system
LIST - Display information about one or all servers
SHOW - Synonym for LIST
CONNECT - Connect to a server via remote console
USE - Synonym for connect
HELP - Displays summary of valid commands
EXIT - Exit this procedure
ADD Command
To add an access server to the system, use the following command format:
ADD [SERVER] [server-name]
The following table describes the command syntax:
After you enter the ADD command, DSV$CONFIGURE displays a series of
prompts. Some prompts display with defaults specified in square brackets. The
values of the defaults are based on the running system.
Example: DSV$CONFIGURE ADD Command
This example shows the ADD command on a DECnet/OSI system. In this
example, at the end of each line you must press return to continue.
Command
Component
Description
SERVER An optional keyword as in all DSV$CONFIGURE commands.
server-name An optional way to specify the name. If you do not specify the
name on the command line, DSV$CONFIGURE prompts you for it.