Specifications

3-7
User Interface
Defining Menus
Introduction
This section describes how to define menus and provides examples.
Reference
For complete information about the commands mentioned in this section, refer to
the Cabletron Network Access Software Command Reference guide.
Main Menu
Whenever the server has its factory-set default settings, it stores the main menu in
NVRAM. You can display and modify the default menu using the same
commands that you use for any other menu.
You may find it convenient to use the main menu as a starting point and an
example for creating new menus. For example, to create a new menu entitled
SERVICES based on the main menu, enter the following command:
Local> CHANGE MENU SERVICES FROM MAIN
In effect, the command above copies the main menu and gives the copy the name
SERVICES. To modify the menu SERVICES, use the CHANGE MENU command
as shown in the Example: Sample Definition of a Menu Selection in this chapter.
Main Menu Display
Figure 3-2 shows how the Main Menu displays on the screen: