Specifications

Managing Dial Services
22-10
Example: Show Dialer, Port Security Enabled
In this example, a user on a port with SECURITY enabled would not have access
to the STATUS display since it might provide access to unlisted or sensitive phone
numbers and other information received from the modem.
Local> SHOW DIALER AT_TRADESHOW CHARACTERISTICS
Dial Service: AT_TRADESHOW
Identification: Dial-back from tradeshow
Connections: Enabled
Ports: 1,2,9-14
Phone number: 555-6766
Delay (seconds): 15
Mode: PPP
Username: None
Password: None
Local>
Showing Dialer Service Status
Use the SHOW/LIST/MONITOR DIALER SERVICE service-name STATUS
command to display dialer service status. These commands are similar to the
SHOW SERVICES LOCAL family of commands in usage and syntax.
Example: Show Dialer Status
In following example, port 10 is currently available; the last phone number it
dialed was found to be busy. Ports 9 and 11 are presently in use. Port 13 is actually
dialing a phone number, while port 14 is waiting for a response from the modem.
When the dialer port is initialized prior to making a phone call, the Last
Connection Status field is cleared.
Local> SHOW DIALER AT_TRADESHOW STATUS
Dial Service: AT_TRADESHOW - Available Identification: Dial-back
from tradeshow
Port: User Status Last Connection Status
9 (remote) Connected CONNECTED 14400/LAPM
10 Available BUSY
11 Raymond Connect CONNECTED 9600
12 Available NO ANSWER
13 Jim Dialing No answer
14 Bob Waiting
Local>