Specifications

Configuring and Managing Point-to-Point Protocol (PPP) Ports
20-10
Example: ATCP Characteristics Display
The following example shows a sample ATCP characteristics display:
Local> SHOW PORT 5 PPP ATCP CHARACTERISTICS
Port 5: Server: LAT_08002B26AA94
ATCP Characteristics:
ATCP: Enabled Passive Open: Enabled
Restart Timer: 3 seconds
Max Configure: 10 transmissions
Max Terminate: 2 transmissions
Max Failure: 10 transmissions
ATCP Characteristics Display Field Values
The following table explains the fields in the ATCP characteristics display:
1
This field has a fixed value in this software release.
Field Description Values Default
ATCP Indicates if ATCP is enabled. Enabled
Disabled
Enabled
Passive Open
1
When enabled, ATCP negotiation does not
begin until initiated by the attached device.
Enabled
Disabled
Enabled
Restart Timer Indicates the amount of time between ATCP
configure- or terminate-request retransmissions
when there is no response.
1 to 5
seconds
3
Max Configure The number of times that ATCP sends a
configure-request packet to the peer without
receiving an acknowledgment.
1 to 15
attempts
10
Max Terminate The number of times that ATCP sends a
terminate-request packet to the peer without
receiving an acknowledgment.
1 to 15
attempts
2
Max Failure The number of times that ATCP sends a
negative acknowledgment for the peer’s
proposed options before deciding to reject the
options.
1 to 15
attempts
10