Specifications

20-9
Configuring and Managing Point-to-Point Protocol (PPP) Ports
1
This field has a fixed value in this software release.
ATCP Characteristics
The SHOW/LIST/MONITOR PPP ATCP CHARACTERISTICS command
displays the ATCP configuration for a given port. The fields in the display show
the latest values configured by the SET PORT n PPP ATCP characteristic
commands. Use the SHOW/MONITOR PORT n PPP ATCP STATUS command to
see the values actually used on the link.
Restart Timer Indicates the amount of time between IPCP
configure- or terminate-request retransmissions
when there is no response.
1 to 5
seconds
3
Max Configure The number of times that IPCP sends a
configure- request packet to the peer without
receiving an acknowledgment.
1 to 15
attempts
10
Max Terminate The number of times that LCP sends a
terminate-request packet to the peer without
receiving an acknowledgment.
1 to 15
attempts
2
Max Failure The number of times that IPCP sends a negative
acknowledgment for the peer’s proposed
options before deciding to reject the options.
1 to 15
attempts
10
Negotiate
Address
Indicates if IP address negotiation is enabled for
this link.
Enabled
Disabled
Disabled
Remote IP
Address
Indicates the address that the access server
should negotiate to use for the peer and the
source of the port’s remote IP address.
0.0.0.0
Compress
Header
Indicates that TCP/IP header compression is to
be used.
Enabled
Disabled
Disabled
Compress States Indicates the maximum number of TCP/IP
sessions that can be compressed at any given
time.
4 to 16 16
Field Description Values Default