Specifications

Configuring and Managing Point-to-Point Protocol (PPP) Ports
20-6
Displaying PPP Characteristics
Introduction
This section describes the commands used to display characteristics for LCP,
IPCP, and ATCP.
Displaying LCP Characteristics
Use the SHOW PORT n PPP LCP CHARACTERISTICS command to display LCP
characteristics for a port. This command is nonprivileged. The fields shown in the
LCP display show the latest values configured by the SET PORT n PPP LCP
characteristic commands. Use the SHOW/MONITOR PORT n PPP LCP STATUS
command to see the values actually used on the link.
Example: Displaying LCP Characteristics
The following example shows the command to display the LCP configuration for
port 5.
Local> SHOW PORT 5 PPP LCP CHARACTERISTICS
Port 5: Server: LAT_08002B26D0E7
LCP Characteristics:
LCP: Enabled Passive Open: Disabled
Restart Timer: 3 seconds
Max Configure: 10 transmissions
Max Terminate: 2 transmissions
Max Failure: 10 transmissions
LCP Options: Local:
MRU: 1500
Character Map: FFFFFFFF
Link Quality: Disabled
Magic Number: Disabled
PF Compress: Disabled
ACF Compress: Disabled
FCS Size: 16 Bit
Callback Disabled