Specifications

19-19
Configuring and Managing 3270 Terminal Emulation (TN3270)
Commands to Manage TN3270 Terminal Emulation
Introduction
This section summarizes the commands to manage 3270 emulation.
Reference
For a complete description of these commands and the correct syntax, refer to the
Cabletron Network Access Software Command Reference guide.
TN3270 Access Server Characteristics
The following table summarizes the TN3270 commands that configure access
server characteristics:
Command Description Default
SET/DEFINE/CHANGE
TN3270 ATOE
Changes the ASCII-to-
EBCDIC translation for
the code specified.
For the default ASCII-to-
EBCDIC translation table,
refer to the Cabletron
Network Access Software
Command Reference. guide
SET/DEFINE/CHANGE
TN3270 ETOA
Changes the EBCDIC-to-
ASCII translation for the
code specified.
For the default EBCDIC-
to-ASCII translation table,
refer to theCabletron
Network Access Software
Command Reference guide
SET/DEFINE/CHANGE
TN3270 TERMINAL
Creates an access server-
wide customized TN3270
terminal or renames an
existing keymap for a
terminal.
For the default KEYMAP,
refer to the Cabletron
Network Access Software
Command Reference.
CLEAR/PURGE TN3270
TERMINAL
Clears dynamic or
permanent memory of a
customized 3270 terminal.
None
SET/DEFINE/CHANGE
TN3270 KEYMAP
Customizes keymappings
for an existing access
server-wide keymap.
None