Specifications

17-5
Configuring for SNMP Access
Configuring the Access Server for SNMP Access
Enabling and Disabling SNMP
The access server must have an Internet address to enable SNMP. To enable
SNMP, enter:
Local> CHANGE SNMP ENABLED
To disable SNMP, enter:
Local> CHANGE SNMP DISABLED
Displaying Information About SNMP
Use the SHOW SNMP command to display the access server’s SNMP
characteristics.
Example: Displaying SNMP Information
The following example shows how to display SNMP information on the access
server:
Local> SHOW SNMP
SNMP State: ENABLED AUTHENTICATION FAILURES: ENABLED
Community Name Address GET GETNEXT SET TRAP
PUBLIC ANY ENA ENA DIS DIS
SNUGS ANY ENA ENA ENA DIS
BUGS 195.1.1.1 ENA ENA ENA DIS
SERVER 195.1.1.2 ENA ENA ENA ENA
Default Community Name PUBLIC
The CHANGE SNMP ENABLED command automatically configures the access
server with the default community name PUBLIC. This community name follows
the default behavior for the SNMP operations listed in the Supported SNMP
Operations section in this chapter.
Configuring a Community Name for Access by Any NMS
Use the CHANGE SNMP COMMUNITY community-name SET ENABLED
command to create a community name.