Specifications

13-3
Configuring and Managing LAT Services
Configuring a Port to Offer a LAT Service
Configuration Parameters
After you attach a device to a port and ensure that the port and device
characteristics match, you need to specify certain configuration parameters to
enable all devices as LAT services.
The following table lists the configuration parameters. In addition to the
parameters listed in the table, you need to configure certain parameters for
specific types of devices as described in the Configuration of Specific Types of
Devices As LAT Services section in this chapter.
For This
Parameter:
Use This Command:
And Refer to This
Section and Chapter:
Service
Groups
CHANGE SERVER SERVICE GROUPS
ENABLED
Changing Access Server Service Groups
in Chapter 6
Authorized
groups
CHANGE PORT AUTHORIZED
GROUPS ENABLED
Configuring LAT Group Codes for
Interactive Devices in Chapter 11
Service name CHANGE SERVICE NAME
CHARACTERISTIC[S]
Assigning a Service Name (in this
chapter)
Port name CHANGE PORT n NAME Assigning a Port Name (in this chapter)
ID string CHANGE SERVICE NAME
Assigning an Identification String (in
this chapter)
Modem
control
CHANGE PORT n SIGNAL CONTROL
ENABLED
Specifying MODEM CONTROL and
SIGNAL CONTROL in Chapter 10
Signal
control
CHANGE PORT n MODEM
CONTROL ENABLED
Specifying MODEM CONTROL and
SIGNAL CONTROL in Chapter 10
Service
Password
CHANGE SERVICE NAME
PASSWORD WORD
Specifying the Service Password (in this
chapter)