Specifications

Configuring and Managing Interactive Devices
12-10
No default entry exists for the REMOVE QUEUE command, and failure to specify
what entry or entries are to be removed from the queue results in an error. The
following sets of entries can be removed:
• A specific entry by using the REMOVE QUEUE ENTRY entry-number
command for each entry
• The entries from a specific requesting node by using the REMOVE QUEUE
NODE node-name command
• The entries for a specific requested service by using the REMOVE QUEUE
SERVICE service-name command
• All queue entries by using the REMOVE QUEUE ALL command
Effect on the Queue
The REMOVE QUEUE ALL command deletes all queue entries, but it does not
disable the queue; the next connection request takes position 1 in the queue.
Example: Remove Queue
The following example shows how you can remove entry number 10 by using the
following privileged command:
Local> REMOVE QUEUE ENTRY 10
Configuring Port Characteristics
The port characteristic, remote modification, when enabled, allows a LAT node to
modify particular access server port characteristics. These characteristics include
speed, character size, parity, and LOSS NOTIFICATION. The LAT node must also
support this feature. The factory-set default is disabled.
You should avoid enabling remote modification and security on the same port.
Enabling these characteristics allows a secure user to modify the port from the
host; normally the secure user cannot modify the port.
Example: Configuring Remote Modification for Port Characteristics
The following example shows how to enable remote modification on port 5:
Local> CHANGE PORT 5 REMOTE MODIFICATION ENABLED