Specifications

11-7
Configuring Modem Signals
The MODEM CONTROL or SIGNAL CONTROL characteristic can only be
configured in the permanent database; therefore, you cannot use the SET or
CHANGE command to configure MODEM CONTROL or SIGNAL CONTROL.
Example: Enabling MODEM CONTROL
The following example shows how to enable MODEM CONTROL on port 5:
Local> DEFINE PORT 5 MODEM CONTROL ENABLED
Local> LOGOUT PORT 5
Example: Enabling SIGNAL CONTROL
The following example shows how to enable SIGNAL CONTROL on port 11:
Local> DEFINE PORT 11 SIGNAL CONTROL ENABLED
Local> LOGOUT PORT 11
Normally, you should disable SIGNAL CHECK when MODEM CONTROL or
SIGNAL CONTROL is enabled.