Specifications

Configuring Basic Device Characteristics
10-2
Configuring Basic Device Characteristics
Introduction
If you attach a standard ANSI video terminal to an access server port, the basic
device characteristics described in this chapter are the only ones that you need to
consider.
If you are configuring a port to communicate with a modem, PC, computer
interface, or nonstandard terminal, refer to the signal characteristics described in
Chapter 10 in addition to the characteristics described in this chapter.
Command
To configure or modify a basic device characteristic, use the
SET/CHANGE/MODIFY command for the appropriate characteristic.
Basic Device Characteristic Summary
The following table summarizes the basic device characteristics, and refers you to
related information in this chapter:
Characteristic Default Allowed Values Refer to Section
ACCESS Local Local, Remote,
Dynamic, None
Configuring the ACCESS
Characteristic
AUTOBAUD Enabled Enabled, Disabled AUTOBAUD
CHARACTER SIZE 8 7, 8 CHARACTER SIZE
DSRLOGOUT Disabled Enabled, Disabled Specifying DSRLOGOUT
FLOW CONTROL XON XON, DSR, CTS,
DISABLED
Flow Control Types
INACTIVITY
LOGOUT
Disabled Enabled, Disabled Specifying INACTIVITY
LOGOUT
INPUT FLOW
CONTROL
Enabled Enabled, Disabled FLOW CONTROL
Direction
LONGBREAK
LOGOUT
Disabled Enabled, Disabled Specifying LONGBREAK
LOGOUT
OUTPUT FLOW
CONTROL
Enabled Enabled, Disabled FLOW CONTROL
Direction