Specifications

Command Descriptions
2-18
DELAY minutes
Specifies that the initialization procedure is delayed by the specified number of
minutes (range: 0 to 1440; default: 1 minute).
DISABLE
Prevents the CONNECT command and the AUTOCONNECT function after an
initialization. To enable CONNECT and AUTOCONNECT, enter INITIALIZE
without the DISABLE option.
DIAGNOSE
Specifies that a test is to be done on the access server hardware. You can specify
the self-test you want to perform. If you omit DIAGNOSE, the access server
performs the standard self-test (NORMAL).
BRIEF
Performs internal self-test functions only.
FULL
Performs extended tests, including in-depth memory test.
NORMAL
Performs the standard self-test.
COUNT n
Specifies that the test repeats n times, range: 1 (default) to 32767.
LOOP
Specifies that the test runs indefinitely. You must interrupt the access server
power source to stop the test.
FACTORY
Performs the software equivalent of holding down the reset-to-factory button.
Example: INITIALIZE
Local> INITIALIZE DELAY 5
This command specifies initialization of the access server after 5 minutes have
elapsed.
Restriction
If the specified load from Flash RAM fails, the firmware will print a warning
message and then attempt a reboot. Flash RAM must be installed on your system
for the program to support Flash RAM.