User`s guide

Bridge Setup Screen
Local Management User’s Guide 1-29
Bridge Setup Screen
The Bridge Setup screen enables you to select a Spanning Tree protocol and enable/disable bridge
ports. Access the Bridge Setup screen, shown in Figure 1-11, by using the arrow keys to highlight
the Bridge Setup option and pressing ENTER. The Bridge Setup screen displays.
Figure 1-11 Bridge Setup Screen
Bridge Setup Screen Fields
The following list describes each of the Bridge Setup screen fields:
SPANNING TREE PROTOCOL — Use this field to select a Spanning Tree protocol. Possible
selections for this field are IEEE 802.1, DEC, or NONE.
BRIDGE PORT ADMIN STATUS — Use this field to enable or disable individual HSIM or
CyberSWITCH bridge ports. Possible selections for this field are ENABLED or DISABLED.
BRIDGE PORT PAIR ADMIN STATUS — Use this field to enable or disable bridging between
bridge port pairs. For example, you can enable Port 1 to bridge traffic to all ports except Port 2.
BRIDGE_PORT XX — Use this command field to select the HSIM or CyberSWITCH bridge port
you want to configure.
BRIDGE SETUP
SPANNING TREE PROTOCOL:
BRIDGE PORT ADMIN STATUS:
BRIDGE PORT PAIR ADMIN STATUS:
SAVE
[IEEE 802.1]
PORT 01 --> ALL PORTS
PORT XX --> PORT [02]
BRIDGE_PORT [01]
RETURN
[ENABLED]
[ENABLED]
201208
<host name> Local Management Flash Image Version: 02.XX.XX