User`s guide

Appendix C: WPIM-DI Configuration
C-4 Local Management User’s Guide
Figure C-3 Sample Timeslot Configuration
Site #1 is using the full T-1, so all the timeslots must have an Interface assignment. Site #2 and Site
#3 only use a fraction of the T-1, but the total quantity of timeslots must match those of Site #1.
Unused timeslots receive an Interface number of 000.
NOTE
When the Drop-and-Insert function is enabled, and the WPIM-DI Physical Configuration
screen is saved, the timeslots will display “DI” to reflect that these timeslots are mapped
to the DI interface. If the Drop-and-Insert function is disabled, the timeslots will display
“000” in the Timeslot Configuration table when the screen is saved.
In order to map unused timeslots to another device connected to the DI port of the
WPIM-DI, the DI Enable option on the WAN Physical Configuration screen must be set
to On.
148203
005
005
000
005
005
000
005
005
000
005
005
000
005
005
000
005
005
000
005
005
000
005
005
000
SITE #2
01-08
09-16
17-24
SITE #3
01-08
09-16
17-24
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
01-08
09-16
17-24
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
000
000
006
SITE #1B
SITE #1A
01-08
09-16
17-24
005
005
D/I
005
005
D/I
005
005
D/I
005
005
D/I
005
005
D/I
005
005
D/I
005
005
D/I
005
005
D/I