User`s guide

Appendix B: WPIM-E1 Configuration
B-10 Local Management User’s Guide
WPIM-E1 Interface Configuration
This screen is accessed from the WAN Physical Configuration screen. Proceed with the following
steps to configure the WAN Interface through Local Management.
1. Access the WAN Interface Configuration screen by using the arrow keys to highlight the WAN
Int Config option and then press ENTER.
2. If the correct Interface number to be configured is not displayed, enter it by typing the number
into the Interface Number field or select it using the SPACE bar, then press ENTER (see note
on page B-6).
3. Unless the user sets the Max Xmit Unit, the WPIM-E1 automatically sets the Max Xmit Unit
to 8191 (default) after the active protocol (PPP) is selected.
4. Configure other settings, including ECP and CCP, as desired.
5. Use the arrow keys to highlight the SAVE command, then press ENTER. The message “Save
Done!” displays and Local Management saves the changes to memory.
The WAN configuration is complete. It takes up to 60 seconds for the WAN Interface to come out
of standby and for communications to begin.
FRAME RELAY CONFIGURATION
This section provides step-by-step instructions for configuring the WPIM-E1 to use an E1 circuit
in a Frame Relay environment. This example assumes the setup shown in Figure B-7, using two
host platforms each containing a WPIM-E1. Configurations may vary depending on the host
platform.
Figure B-7 Frame Relay Configuration
SITE 1
Telco Cloud
32 Timeslots
(31 customer-usable)
32 Timeslots
(31 customer-usable)
SITE 2
1484_05