User`s guide

WAN Configuration
2-36 Local Management User’s Guide
Configure Primary Lines and Routing
Configure the primary lines. Refer to the appropriate WPIM user’s manual. Configure routing if
used. Refer to the appropriate host platform user’s manual.
Select the Protocol
Select the ISDN Protocol Manager for the HSIM or CyberSWITCH in Local Management, using
the WAN Physical screen.
Begin the HSIM or CyberSWITCH configuration by accessing the WAN Physical Configuration
screen through Local Management. Access the WAN Physical Configuration screen from the WAN
Setup menu item that displays in the Setup Menu in Local Management. Use the arrow keys to
highlight the WAN Setup menu item, then press ENTER. The screen shown in Figure 2-16
displays.
Figure 2-16 WAN Physical Configuration Screen
NOTE
Network Tools can be found in the MIB NAVIGATOR selection in the main menu of
Local Management for the host platform.
SAVE WAN INT CONFIG RETURN
Type: S/T
WPIM #: 2
Mgr Type: [ISDN BRI]
Max VCs: 002
Next IF: N/A
Type: T1
WPIM #: 1
Mgr Type: [PPP]
Max VCs: 024
Next IF: 007
WAN PHYSICAL CONFIGURATION
148301
<host name> Local Management Flash Image Version: xx.xx.xx
[WPIM 2]
WPIM 1 WPIM 2
REMOTE SETUP