User`s guide

WAN Configuration
2-30 Local Management User’s Guide
The line configuration information shown in Table 2-4 must be supplied by the service provider.
DDS Service Physical Configuration
Begin the DDS configuration by accessing the WAN Physical Configuration screen (Figure 2-14)
through Local Management. To access the WAN Physical Configuration screen, use the arrow keys
to highlight the WAN Setup option, then press ENTER. The screen shown in Figure 2-14
displays.
Figure 2-14 WAN Physical Configuration Screen for DDS Service
Table 2-4 Telco Configuration Information
Configuration Information
Required By User
Configuration Information
Supplied By Service Provider
Clock Source Telco provided or no clock source
Line Mode Primary or Clear Channel
FR-LMP (Frame Relay Only) Telco provided or user requested
SAVE WAN INT CONFIG RETURN
Type: DDS
WPIM #: 1
MgrType: [None]
Max VCs: 000
Next IF: N/A
WAN PHYSICAL CONFIGURATION
DDS Line Mode:
DDS Tx Clock Source:
DDS Loop-Back:
WPIM 1 Line Configuration
2750_01
<host name> Local Management Flash Image Version: 02.xx.xx
[WPIM 1]
WPIM 1
[DDS-PRI]
[Loop-Timing]
[NONE]
DDS In-Speed:
DDS Out-Speed:
56000
56000
REMOTE SETUP