Specifications

Wide Area - 1 and 2 Configuration Windows
QuickSET Configuration Guide 83
Wide Area DDS - Configuration Window
The Wide Area DDS configuration window is shown in Figure 90 below. This section explains
how to configure the Wide Area DDS interface using QuickSET.
Figure 90 Wide Area DDS Configuration Window
Table 6, below, shows the line configuration information normally determined by your service
provider. The factory default settings are in bold.
This section describes the fields in the Wide Area DDS configuration window.
DDS Line Mode — Displays the DDS Line Mode. The selections for this field are DDS-PRI 56K
(primary) and DDS-CC 64K (clear channel). This information is determined by the service
provider. The default setting is DDS-PRI.
Table 6 Telco Configuration Information
Configuration Information
Required by User
Configuration Information
Supplied by Service Provider
DDS Line Mode DDS-PRI or DDS-CC
DDS Clock Source Loop-Timing or Local-Timing
DDS Loop Back No Loop or Line Loop