Specifications

Configuration with QuickSET
70 QuickSET Configuration Guide
The following definitions explain the fields in the System Passwords window.
Read Only Access — This access level allows reading of device parameters not including
system passwords. Place the cursor in this field and type the new system password. Retype the
system password in the Confirm Password field below the Read Only Access field.
Read/Write Access — This access level allows editing of some device configuration parameters
not including changing system passwords. Place the cursor in this field and type the new system
password. Retype the system password in the Confirm Password field below the Read/Write
Access field.
QuickSET (SuperUser) — This access level allows full management privileges. Place the cursor
in this field and type the new system password. Retype the system password in the Confirm
Password field below the QuickSET (SuperUser) field.
When you have finished configuring the system passwords, click on the O
K button in the System
Passwords window to return to the Ethernet 1 and 2 configuration window, or the Local HSIM IP
Address window.
When you have completed Ethernet configuration, click on the N
ext>> button and go to the Wide
Area - 1 and 2 Configuration Windows section.
Wide Area - 1 and 2 Configuration Windows
!
CAUTION
If you edit the SuperUser system password, be certain not to forget it. If you do, you
cannot perform management functions without returning the device to its factory default
configuration. This effectively erases any configuration work you may have done.
NOTE
When configuring WAN interfaces 1 and 2 with QuickSET , the Wide Area configuration
window that displays corresponds to the specific WPIM that is installed into the device.
NOTE
Configuration for the Wide Area 2 interface is the same as the configuration for the
Wide Area 1 interface. Note that the CSX500 and HSIM-W84 will always have four
WPIM-T1s installed.