Specifications

Configuration with QuickSET
56 QuickSET Configuration Guide
The Add route window (shown below in Figure 58) appears when you click the Add button on the
OSPF Redistribute Routes window. Enter the new values for the route to be redistributed and click
O
K when you have finished.
Figure 58 Add Route Window
The IP Route Warning message (shown below in Figure 59) will appear if you incorrectly specify
the any of the parameters (i.e., subnet mask, Destination, or Next Hop) defining the static route in
the Add Route window. QuickSET checks the IP address and Mask, and will not accept an
incorrectly defined route.
Figure 59 IP Route Warning Message
The Modify Route window (shown in Figure 60 on the following page) appears when you click
the Modify button on the OSPF Redistribute Routes window. This window is used to modify an
existing route in the redistribute routes data base. Enter the new data into the respective windows,
and click O
K when you have finished.