Specifications

Bridging and Routing Configuration
QuickSET Configuration Guide 45
When you have finished making changes, click the OK button to exit the Modify IPX Host
window. Click Done on the IPX Host Map window, and return to the (IP/IPX) Routing
Configuration window. When you have completed your configuration, click on the S
ave button to
save any configuration changes you have made. The Congratulations window displays. Click on
the O
K button to exit QuickSET.
Advanced Routing Configuration Window
Figure 44 Advanced Routing Configuration Window
The Advanced Routing configuration window (shown in Figure 44 above) displays after you click
on the Advanced button in the (IP/IPX) Routing Configuration Window. Use this window to
enable Routing Information Protocol (RIP) routing, set an IP address for a remote DHCP server
(redirector), set up Network Address Translation (NAT) or set up OSPF and IP Host Map.
If you wish to run your WAN connection in Numbered Mode, enter the Local WAN IP Address
Subnet Mask for Numbered Mode. If you wish to use Unnumbered Mode, leave these fields blank.