Specifications

Configuration with QuickSET
42 QuickSET Configuration Guide
When Split Horizons is disabled (OFF) for any of the above protocols, all protocol information
received on that port will be rebroadcast back out that port, for example, to allow other DLCIs
(Data Link Connection Identifiers) on this port, that have not received these packets, to receive this
information. The Modify panel shown in Figure 40, below, displays after you have selected an
Interface Number and clicked on the M
odify button.
Figure 40 Modify Split Horizons panel
IPX Routing Configuration
This section describes the fields in the IPX Routing Configuration window.
Interface # — Displays all interface numbers that can be assigned an IPX network number.
Network # — Displays the active IPX network number assigned to an interface.
Host Map... — The IPX Host Map button takes you to the IPX Host Map window. IPX Host Map
entries are used for IPX routing in Frame Relay mode only.
Modify... — Use this button to change an entry in the IPX Routing Configuration window. Select
the interface number to modify by clicking on the tab to the left of the interface number.
IPX Host Map Window
The IPX Host Map window shown in Figure 41 on the following page, displays after clicking on
the Ho
st Map... button in the (IP/IPX) Routing configuration window. Host Map entries are used
for IPX routing using Frame Relay Protocol only. The IPX Host Map is a database of remote IPX
hosts, defined (generally) by the WAN Network number and MAC Address, and (more
specifically) by the Interface Number and Data Link Connection Identifier (DLCI).