Specifications

Configuration with QuickSET
108 QuickSET Configuration Guide
.
Figure 118 Modify Backup Window
The following are definitions of Dial-Up Settings parameters:
Time to Connect — Time to Connect lets you configure the seconds to wait, before attempting to
switch over to the back-up interface. The default is zero. Allowed values are in increments of five
seconds, to a maximum of 10,000 seconds.
Time to Disconnect — Time to Disconnect allows you to configure the amount of seconds the
restored primary interface must remain connected, before attempting to switch over from the
back-up interface. The default value is 90 seconds. Allowed values are in increments of five
seconds, up to a maximum of 10,000 seconds. A value of zero is acceptable.
Connect Retries — Connect Retries allows you to configure the number of tries to restore the
back-up interface, before giving up. The default value is three. Allowed values are in increments of
one, up to a maximum of 10,000. A value of zero is acceptable.
Retry Interval — Retry Interval lets you set up the time between retries (maximum 60 seconds).
Override Primary Connection — Override Primary Connection forces the back-up interface to
remain connected, and does not allow the back-up interface to switch back to the primary
interface, even if the primary interface is restored.