User`s guide

Small Office Remote Access Switch 73
C ONFIGURING R ESOURCES AND L INES
Lines
5. Add the necessary data links.
a. Select Automatic TEI Negotiation UNLESS this is a point-to-point NTT line.
b. If you need to assign a TEI Negotiation value, the default value of 0 is normally correct.
c. Only if you plan on using X.25 over the D-Channel on this line, answer yes to the following
prompt:
6. If the line uses a NI-1 or a DMS-100 switch type, you must also enter the following:
a. SPID(s) - supplied by your carrier
b. Directory Number(s) associated with the SPID(s) - supplied by your carrier
c. Number of digits to verify.
C
ONFIGURING CHANGES FOR A COMMPORT RESOURCE
1. Select Change from the Data Lines menu of Physical Resources.
2. Select ASYNCDMPORT.
3. You will be prompted to accept the default or provide new information for the following:
a. baud rate
b. data bits
c. stop bits
d. parity value
e. flow control type
f. mode:
• Autosense (default): can be either terminal or PPP-async. Requires user interaction
(four carriage returns) to get to terminal mode.
• Term: terminal mode only. Login prompt automatically sent to remote console.
U
SING MANAGE MODE COMMANDS
line
Displays the current line configuration.
datalink
Display the current data link configuration.
Will this Data Link support X.25 communications (Y/N)? [default N]