User`s guide

USER’S GUIDE
598 CyberSWITCH
sentry radius attempts an authentication session using RADIUS
sentry status displays current status of user level authentication servers
sentry log logs rejection messages from the authentication server
session displays the current active administration sessions
session kill <session id> terminates the active session specified by the session id
snmp stats displays current SNMP related statistics
sp lists each semi-permanent device and associated status
status (GUEST) displays system errors and system messages
tcp conns displays the current TCP connection status
tcp stats displays the current system TCP statistics
telnet puts you in the Telnet command mode
see
telnet mode commands for available commands
telnet <ip-address>[port #] begins a Telnet session for the indicated Telnet host
telnet mode commands:
close
exit
open [target host][port #]
send [send parameter]
set <name><value>
status
toggle
closes the current Telnet connection to a target host
closes the current Telnet session
establishes a Telnet session with a target host
sends special Telnet control functions to the currently
connected target host
sets operating parameters for the current Telnet session
provides information about the current Telnet session
sets operating parameters for the current Telnet session
term displays the terminal type.
term set <terminal type> sets the terminal type
tftp get invokes the TFTP GET command
tftp put invokes the TFTP PUT command
tftp session displays TFTP session statistics
tftp session kill <session id> terminates the active TFTP session specified by the session
id
tftp stats (GUEST) displays the current TFTP statistics
tim e [hours:m in utes:seconds] displays or changes current system time
trace [on/off] enabled or disables call trace information reports
trace ipxwan [on/off] enables or disables the IPXWAN tracing option
Command
Use