User`s guide

USER’S GUIDE
512 CyberSWITCH
cdr verify
Generates a sample message to all servers that have been configured for CDR. A message
similar to the following will be displayed:
<system name> CDR VERIFY 1 of 1
Refer to Log Commands for the commands that will allow you to display or erase CDR log reports.
CALL RESTRICTION COMMANDS
When the Call Restriction feature is enabled on the CyberSWITCH, the following command is
available through the administration console:
cr stats
Displays the current Call Restriction statistics. Refer to Call Restriction Statistics, for a list of
available statistics and their definitions.
Other Call Restriction commands are available through Dynamic Management. Refer to
Configuring Call Control for these commands.
COMPRESSION INFORMATION COMMANDS
Compression statistics are only available for connections that are using a compression protocol.
The following commands are used to display current compression information:
cmp stats
Displays the compression statistics for all active connections. Refer to Compression Statistics, for
a list of available compression statistics and their definitions.
cmp stats <device name>
Displays the compression statistics for the indicated device. Refer to Compression Statistics, for
a list of available statistics and their definitions. Note that the device name is case sensitive.
cmp clear <device name>
Clears the compression statistics for the indicated device. If the device name is omitted, no
compression statistics will be cleared. Note that the device name is case sensitive.
cmp clearall
Clears the compression statistics for all devices.
DHCP COMMANDS
These commands allow you to display or erase DHCP statistics.
DHCP stats
Displays the DHCP statistics. For a listing of available statistics and their definitions, refer to
DHCP Statistics.
DHCP stats clear
Clears the DHCP statistics.